For Your Safety Read Before Operating - Weil-McLain CGi User's Information Manual

Operating instructions
• Spark-ignited pilot
• Gas valve — Honeywell VR8204/VR8304

FOR YOUR SAFETY READ BEFORE OPERATING

A. This appliance is equipped with an ignition
device which automatically lights the pilot.
try to light the pilot by hand.
not
B. Before
OPERATING
appliance area for gas. Be sure to smell next to
the floor because some gas is heavier than air and
will settle on the floor. See below.
• Do not try to light any appliance.
• Do not touch any electric switch; do not use any phone
in your building.
1. Read the safety information above on this label.
Stop!
2. Set the thermostat to lowest setting.
3. When equipped with
Effikal
place service switch in
4. Turn off all electrical power to the appliance.
5. When equipped with
manually rotate damper blade in direction
Model M35,
of arrow to position indicated on damper assembly.
Open
6. This appliance is equipped with an ignition device which
automatically lights the pilot.
by hand.
7. Turn gas control knob clockwise
Position
indicator
(shown in
ON position)
59331
1. Set the thermostat to lowest setting.
2. Turn off all electric power to the appliance if service is to
be performed.
3. Remove front panel.
16
If you do not follow these instructions exactly, a fire or explosion may
result causing property damage, personal injury or loss of life.
Do
, smell all around the
WHAT TO DO IF YOU SMELL GAS
OPERATING INSTRUCTIONS
vent damper
Model RVGP ,
position.
Hold Damper Open
vent damper
Johnson Controls
try to light the pilot
Do not
to .
OFF
Gas
control
knob
TO TURN OFF GAS TO THE APPLIANCE
CGa, EG-30 to EG-75,
PEG-30 to PEG-55,
PFG-5
C. Use only your hand to turn the gas control knob. Never use tools. If
the knob will not turn by hand, don't try to repair it, call a qualified
service technician. Force or attempted repair may result in a fire or
explosion.
D. Do not use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect the appliance
and to replace any part of the control system and any gas control,
which has been under water.
• Immediately call your gas supplier from a neighbor's
phone. Follow the gas supplier's instructions.
• If you cannot reach your gas supplier, call the fire
department.
8. When equipped with vent damper, verify damper blade
is in full open position.
9. Wait five (5) minutes to clear out any gas. Then smell for
gas, including near the floor. If you smell gas,
in the safety information above. If you don't smell
"B"
gas, go to the next step.
10. Turn gas control knob counterclockwise
11. Turn on all electric power to the appliance.
12. When equipped with
switch in
Automatic Operation
13. Set thermostat to desired setting.
14. If the appliance will not operate, follow the instructions
To Turn Off Gas To The Appliance
technician or gas supplier.
15. Replace front panel.
4. Turn gas control knob clockwise
force.
5. Replace front panel.
Follow
STOP!
to
ON
vent damper, place service
Effikal
position.
and call your service
to . Do not
OFF
Part Number 550-110-592/1000
.