Weil-McLain CGi User's Information Manual page 21

Operating instructions
• Spark-ignited pilot
• Gas valve — Honeywell VR8204/VR8304, White-Rodgers 36C and 36E
FOR YOUR SAFETY READ BEFORE OPERATING
A. This appliance does not have a pilot. It is equipped
with an ignition device which automatically lights
the burner. try to light the burner by hand.
Do not
B. Before
OPERATING
appliance area for gas. Be sure to smell next to the
floor because some gas is heavier than air and
will settle on the floor. See below.
• Do not try to light any appliance.
• Do not touch any electric switch; do not use
any phone in your building.
1. ! Read the safety information above on this label.
STOP
2. Set the thermostat to lowest setting.
3. Turn off all electrical power to the appliance.
4. Remove jacket front panel.
5. This appliance is equipped with an ignition device which automatically lights the burner.
Do not try to light the burner by hand.
6. Turn
Gas control knob
7. Wait five (5) minutes to clear out any gas. Then smell for gas, including near the floor. If
you smell gas, ! Follow "B" in the safety information above. If you don't smell gas,
STOP
go to the next step.
8. Turn
Gas control knob
9. Turn on all electric power to the appliance.
10. Set thermostat to desired setting.
11. If the appliance will not operate, follow the instructions "
" below and call your service technician or gas supplier.
APPLIANCE
12. Replace jacket front panel.
1. Set the thermostat to lowest setting.
2. Turn off all electric power to the appliance if service is to
be performed.
Part Number 550-110-592/1000
If you do not follow these instructions exactly, a fire or explosion may
result causing property damage, personal injury or loss of life.
, smell all around the
WHAT TO DO IF YOU SMELL GAS
OPERATING INSTRUCTIONS
clockwise to .
OFF
counterclockwise to
ON
TO TURN OFF GAS TO THE APPLIANCE
CGi, CGs
C. Use only your hand to turn the gas control knob. Never use
tools. If the knob will not turn by hand, don't try to repair it,
call a qualified service technician. Force or attempted repair
may result in a fire or explosion.
D. Do not use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect the
appliance and to replace any part of the control system and
any gas control, which has been under water.
• Immediately call your gas supplier from a neighbor's phone.
Follow the gas supplier's instructions.
• If you cannot reach your gas supplier, call the fire department.
.
TO TURN OFF GAS TO
3. Remove jacket front panel.
4. Turn
Gas control knob
force.
5. Replace jacket front panel.
26070
White-Rodgers
36C Gas valve
Position indicator
(shown in "ON" position)
Gas control knob
White-Rodgers
36E Gas valve
Position indicator
(shown in "ON" position)
Gas control knob
Honeywell
VR8204 or
VR8304
Gas valve
Position indicator
(shown in "ON" position)
Gas control knob
clockwise to . Do not
OFF
21