Weider WESY78732 User Manual page 9

8. Attach a Large Pulley (14) and the Pulley Plate
(68) to the Upright (2) with an M12 x 62mm
Button Bolt (81) and an M12 Nylon Locknut (13).
Do not tighten the Locknut yet.
9. Pull the upper cable (A), which is attached inside
of the Mech Frame (not shown), up between the
Upright (2) and the Pulley Plate (68).
Attach another Large Pulley (14) to the Upright (2)
and Pulley Plate (68) with an M12 x 62mm Button
Bolt (81) and an M12 Nylon Locknut (13). Make
sure that the upper cable (A) is between the
two Pulleys.
Hold the 38mm Spacer (90) inside the loop of the
upper cable (A), and between the Upright (2) and
the Pulley Plate (68). Attach the Spacer with an
M10 x 58mm Button Screw (11). Make sure the
ends of the cable do not wrap around each
other below the Spacer and the Large Pulleys
(14) used in steps 8 and 9 (refer to the CABLE
DIAGRAM on page 18).
Tighten the M12 Nylon Locknuts (13) used in
steps 8 and 9.
10. Attach a Small Guide Spacer (18), a Large Guide
Spacer (17), and two Crossbar Guides (15) to the
Upright (2) with an M10 x 152mm Bolt (86).
Pull the upper cable (A) up between the Crossbar
Guides (15). Press the metal cover on the cable
into the groove in the Crossbar Block (16). Attach
a Small Guide Spacer (18), the Crossbar Block,
the two Crossbar Guides (15), an M10 Thick
Washer (54), and the two Tethers (70) to the
Upright (2) with another M10 x 152mm Bolt (86). Do
not tighten the Bolt yet.
8
81
9
81
10
18
2
18
9
68
13
14
2
A
11
90
13
68
14
2
17
86
15
Metal
54
Cover
A
70
Groove
16
86