Weider WESY78732 User Manual page 10

11. Insert the Resistance Bar (9) between the
Crossbar Guides (15), and center it on the
Crossbar Block (not shown).
Press a Pulley Bracket (10) onto the Resistance
Bar (9). Screw a 3/8" x 38mm Tension Screw
(117) into the Pulley Bracket a couple of turns.
Make sure the hexagonal hole in the Screw is
on the outside of the Bracket.
Attach a Tether (70) to the Pulley Bracket (10) at
the upper hole, with an M10 x 64mm Button Bolt
(80), an M10 Thick Washer (54), and an M10 Nylon
Locknut (103).
Repeat on the other side of the Resistance
Bar (9). Then, tighten the lower M10 x 152mm
Bolt (86) used in step 10.
12. Hold a Large Pulley (14) inside the upper cable
(A). Attach the Pulley to a Pulley Bracket (10)
with an M12 x 58mm Button Bolt (87) and an M12
Nylon Locknut (13). Make sure that the cable is
routed as shown in the CABLE DIAGRAM on
page 19.
13. Hold a Large Pulley (14) inside the upper cable
(A). Attach the Pulley to the other Pulley Bracket
(10) with an M12 x 58mm Button Bolt (87) and an
M12 Nylon Locknut (13). Make sure that the
cable is routed as shown in the CABLE DIA-
GRAM on page 19.
Tighten the two 3/8" x 38mm Tension Screws
(117) an equal number of turns.
14. Attach the Leg Lever (56) to the Leg (5) with a
Leg Station Pin (60). Slide a Cotter Pin (113) onto
the Leg Station Pin.
11
12
10
87
14
A
13
14
56
10
15
70
54
9
10
80
117
13
13
117
A
10
14
87
5
60
103
113