Page 1
Model No. WEMC07730 QUESTIONS? As a manufacturer, we are com- mitted to providing complete customer satisfaction. If you have questions, or if there are missing or damaged parts, we will guarantee complete satis- faction through direct assis- tance from our factory.
Read all instructions before using. ICON assumes no responsibility for personal injury or property damage sustained by or through the use of this product. WEIDER is a registered trademark of ICON Health & Fitness, Inc. 5. Make sure that all parts are properly tight- ened each time the resistance system acces- sory is used.
6 p.m. Mountain Time (excluding holidays). To help us assist you, please note the product model number before calling. The model number is WEMC07730. Before reading further, please review the drawing below and familiarize yourself with the parts that are labeled.
ASSEMBLY Make Things Easier for Yourself This manual is designed to ensure that the resist- ance system accessory can be assembled suc- cessfully by most people. Before beginning assembly, carefully read the following information and instructions: • Assembly requires two persons. •...
Page 5
3. Note: If your Leg (C) has a hole for the Curl Knob (not shown) in the indicated position, skip to step 11. Remove the two Bolts (G), the four Washers (H), and the two Nylon Locknuts (I) attaching the Leg (C) to the Rail (J).
Page 6
6. Remove the Bolt (N), the two Washers (O), the two Spacers (P), the Nylon Locknut (Q), and the Pulley (R) from the Leg (C). 7. Attach Pulley (R) removed in step 6 inside of the new Leg (14) with the Bolt (N), the two Washers (O), the two Spacers (P), and the Nylon Locknut (Q) removed in step 6.
Page 7
9. Attach the Leg Lever Bumper (L) to the Leg (14) with the two Screws (K) removed in step 4. 10. Attach the Leg (14) to the Rail (J) with the two Bolts (G), the four Washers (H), and the two Nylon Locknuts (I) removed in step 3.
Page 8
12. Attach the Curl Pad (4) to the Curl Post (3) with two M6 x 16mm Screws (2).
ADJUSTMENTS This section explains how to adjust the resistance system accessory. Make sure all parts are properly tightened each time the resistance system accessory is used. Replace worn parts immediately. The resistance system accessory can be cleaned with a damp cloth and a mild, non-abrasive detergent. Do not use solvents. USING THE LEG LEVER To use the Leg Lever (9), attach it to the Leg (14) with a Leg Station Pin (B).
Page 10
ATTACHING THE CURL BAR To use the Curl Bar (8), first attach the leg lever to the leg (see USING THE LEG LEVER on page 9). Attach the Curl Bar to the hook on the Leg Lever (9) with a Cable Clip (13).
PART LIST—Model No. WEMC07730 Key No. Qty. Description Short Handgrip M6 x 16mm Screw Curl Post Curl Pad Pad Tube 19mm Round Inner Cap Large Foam Pad Curl Bar Note: “#” indicates a non-illustrated part. Specifications are subject to change without notice. See the back cover of this manual for information about ordering replacement parts.
Friday, 6 a.m. until 6 p.m. Mountain Time (excluding holidays). To help us assist you, please be pre- pared to give the following information: • The MODEL NUMBER of the product (WEMC07730) • The NAME of the product (WEIDER •...