Weider WESY59531 User Manual page 10

16. Locate the Fulcrum (18) on the Lat Tower (4) (see
the inset drawing). Slide the Tray (35) onto the
rods on the Fulcrum. Make sure the Tray is ori-
ented as shown in the drawing.
Set the resistance bars into the Tray (35) in the fol-
lowing order: the 10-Pound Removable Resistance
Bar (67), the 20-Pound Removable Resistance Bar
(36), an 80-Pound Resistance Bar (95), the 10-
Pound Center Resistance Bar (44), an 80-Pound
Resistance Bar (95), and the 40-Pound Resistance
Bar (96). Make sure the indicated rings are on
the side shown and the arrows point toward
the Tray.
Attach the Cover Plate (72), with the edges up, to
the Tray (35) with two M8 x 19mm Button Head
Screws (86).
17. Locate the Long Cable (80). Insert one end of
the Cable through the welded tube on the indicat-
ed end of the Cross Tube (11) and then through a
Swivel Arm (22). If necessary, use the tip of a
screwdriver to pull the end of the Cable out of the
Swivel Arm. Be sure the Cable is on the indicat-
ed side of the welded rod in the Swivel Arm.
Insert the Swivel Arm (22) into the welded tube
on the Cross Tube (11). Secure the Swivel Arm
with an M4 x 5mm Screw (104).
Wrap the Long Cable (80) around a 90mm Pulley
(28). Attach the Pulley inside of the Swivel Arm
(22) with an M10 x 42mm Button Head Bolt (71)
and an M10 Nylon Locknut (76).
18. Wrap the Long Cable (80) around a 90mm Pulley
(28). Attach the Pulley and a Pulley Guard (29) to
the indicated M10 x 140mm Carriage Bolt (73)
with an M10 Nylon Locknut (76). Be sure the flat
edge of the Pulley Guard is on the side
shown.
19. Attach a Pulley Housing (94) to the indicated "U"-
channel on the 10-Pound Center Resistance Bar
(44) with an M10 x 102mm Button Head Bolt (24),
two Pivot Bushings (74), and an M10 Nylon
Locknut (76).
Wrap the Long Cable (80) around a 90mm Pulley
(28). Attach the Pulley inside of the Pulley
Housing (94) with an M10 x 42mm Button Head
Bolt (71) and an M10 Nylon Locknut (76).
16
Rings on
this side
4
35
18
18
17
18
73
19
74
71
28
10
86
Edges
72
up
96
44
67
Rods
80
71
11
28
76
Flat
Edge
29
76
28
44
76
"U"-Channel
76
94
74
24
80
95
95
36
104
22
Rod
80