Weider WEEVSY87210 User Manual page 6

2. Slide the Front Upright (42) onto the 5/16" x
2 1/2" Carriage Bolts (1) in the Base (4).
Hand tighten a 5/16" Nylon Locknut (3) onto
each Carriage Bolt. Do not tighten the
Nylon Locknuts yet.
Press a 1" Square Inner Cap (65) into the
Front Upright (42).
Attach the slotted end of the Brace (87) to the
5/16" x 2 1/2" Carriage Bolt (1) in the
Stabiliser (5). Hand tighten a 5/16" Nylon
Locknut (3) onto the Bolt. Do not tighten the
Nylon Locknut yet.
Attach the other end of the Brace (87) to the
Rear Upright (56) with a 5/16" x 2 3/4" Bolt
(11), a 5/16" Washer (8), and a 5/16" Nylon
Locknut (3). Do not tighten the Nylon
Locknut yet.
3. Press a 2" Square Inner Cap (27) into the end
of the Top Frame (55). Press a 1 3/4" Square
Inner Cap (44) into each end of the crossbar
on the Top Frame. Press two 1" Round Inner
Caps (49) into the top of the crossbar.
Attach the Top Frame (55) to the Front Upright
(42) and the Rear Upright (56) with four 5/16"
x 2 3/4" Bolts (11), four 5/16" Washers (8),
and four 5/16" Nylon Locknuts (3).
Tighten all Nylon Locknuts used in steps 1
through 3.
4. Press two 1 1/2" Bushings (82) into the Left
Pedal (79). Attach a Pedal Cover (81) to the
Left Pedal with a 1/2" Metal Screw (77).
Assemble the Right Pedal (not shown) in the
same manner.
2
56
11
3
87
5
1
Slot
3
11
27
55
44
3
56
4
82
6
42
8
3
3
4
1
11
8
8
44
49
Crossbar
3
42
77
79
65
81