Advertisement
ATTACHING AND REMOVING THE SEAT
Set the bracket on the Seat Frame (36) onto the indi-
cated pins on the Front Upright (42). Attach the Seat
Frame to the Front Upright with the 5/16" x 2 3/4"
Carriage Bolt (14) and the Seat Knob (40).
For some exercises, the Seat (13) must be removed.
First, be sure that the chain is not attached to the leg
lever. Next, remove the Seat Knob (40) and the 5/16"
x 2 3/4" Carriage Bolt (14) from the Seat Frame (36).
Lift the Seat Frame off the Front Upright (42).
ATTACHING THE LEG LEVER TO THE LOW
PULLEY STATION
To use the Leg Lever (29), the seat must be attached
to the front upright (see ATTACHING AND REMOV-
ING THE SEAT above).
Attach one end of the Chain (52) to the Short Cable
(58) with a Cable Clip (53). Attach the other end of
the Chain to the 5/16" x 2" Eyebolt (35) with a Cable
Clip.
CHANGING THE STEPPING RESISTANCE
To change the stepping resistance, first lift the Right
and Left Pedals (78, 79) off the hooks at the lower
ends of the Resistance Cylinders (80). Move the
hooks to different slots under the Pedals. Make sure
that the hooks are fully inserted into the same
slots on both Pedals. The farther the hooks are
moved from the Rear Upright (56), the greater the
resistance will be. WARNING: The Resistance
Cylinders become very hot during use. Allow the
Resistance Cylinders to cool before touching
them.
14
Pin
58
56
80
79
18
42
40
36
13
52
29
35
53
78
Hide quick links:
Advertisement
