Transferring Priority; Setting The Sound Options; Setting The Clock - Rinnai MC-100V Operation & Installation Manual

Deluxe water controllers
Hide thumbs Also See for MC-100V:
Table of Contents

Advertisement

Transferring Priority

To control the water delivery temperatures when using two or
more controllers it is necessary to have priority transferred to the
water controller you wish to use.
Illuminated On/Off and Transfer buttons confirm that the desired
controller is in control of the water delivery temperature. If the
On/Off button is not illuminated press the Transfer button once,
the On/Off and Transfer buttons will illuminate indicating that hot
water temperature control has been transferred and that the hot
water unit will be ready to supply hot water once a hot water tap
is opened.

Setting The Sound Options

To set the sound options press the Sound Volume button and
select the desired audible setting as follows:
Voice - OFF - LOW - MED - HIGH
Setting the voice prompt volume does not affect the
audible tones�
NOTE
Sound OFF, mutes all voice prompts and audible tones.
Press any of the
or
If no buttons are pressed for a period of
approximately 10 seconds the controller will return
NOTE
to normal operation�

Setting The Clock

The clock is a 12 hour AM/PM style display.
To set the time press the Clock button once, this places the
controller into clock setting mode, in the digital monitor the clock
digits will flash.
Use the Temperature
holding these buttons down continuously cycles the digits.
When you get close to the time you wish to set, press the button
intermittently to avoid going further than the desired time.
To return to normal operation mode press the Clock button once.
If no buttons are pressed for a period of
approximately 60 seconds the controller will return
NOTE
to normal operation�
The time is always displayed regardless of whether
the water controller is turned ON or OFF�
The clock may need resetting if power to the water
heater unit is disrupted due to a power failure or if
the power is switched off over a prolonged period.
The default factory start time is set to AM 12:00�
Rinnai
buttons to return to normal operation.
or
buttons to select the desired time,
WATER CONTROLLER OPERATION
9
HW_CF_DELUXE OIM

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Bc-100v

Table of Contents