Table of Contents
Advertisement
WATER CONTROLLER OPERATION
Setting Shower Saver / Bath Fill
The 'Shower Saver / Bath Fill' function allows a pre-set water volume and temperature to be selected and run
automatically.
No voice prompts will be available if the 'Voice OFF' or 'Sound OFF' options are selected� With
'Sound OFF' there will also be no audible tones�
NOTE
When a deluxe bathroom controller is first turned on, the default
shower / bath fill temperature is set to 40°C and the shower /
bath volume is set to 100 litres.
The shower / bath volume can be lowered to a minimum of 30
litres or raised to a maximum of 400 litres and the temperature
adjusted as desired.
Setting Shower / Bath Temperature and Volume
With the system on, select a Deluxe Bathroom water controller
and ensure that it currently has priority.
If it does not have priority press the Transfer button once and the
Transfer button will illuminate.
Press Shower Saver / Bath Fill button once. The Shower Saver
/ Bath Fill button will illuminate and a voice prompt and tone will
sound.
To select the desired delivery temperature use the 'Temperature'
or
buttons.
The selected temperature will be displayed on the digital
monitor and will remain as the default Shower Saver / Bath Fill
temperature until it is changed or if the mains power is turned off
for an extended period.
To select the volume of water to be used in the shower / bath use
the Water Volume
The selected volume is displayed in large digits to the right and
will remain as the default Water Volume until it is changed or if
the mains power is turned off for an extended period.
The selected volume is also repeated in the form of a remaining
volume counter below the temperature and replaces the clock
during Shower Saver / Bath Fill operations.
When filling a bath for the first time, it is recommended that a low
bath fill volume such as 60 litres or lower be used.
During any subsequent bath fills the volume can then be adjusted
to suit your known bath volume and or desired fill level
Be careful not to overfill the bath, an average bath volume is 160 litres. It is recommended that
when filling a bath for the first time you should:
CAUTION
• Remain by the bath during the filling process.
• Use a low bath fill volume such as 60 litres or less.
When Smartstart® (page 12) is in operation, the Shower Saver / Bath Fill function is unavailable
while the water heater 'In Use' indicator
Do not press the Preheat button whilst Shower Saver / Bath Fill is in operation as the programmed
bath fill volume will not be met.
Rinnai
or
buttons.
is illuminated�
10
HW_CF_DELUXE OIM
Hide quick links:
Advertisement
Table of Contents
