WATER CONTROLLER INSTALLATION
Location
DO NOT install water controllers near a heat source, such as a cook top, stove or oven� Heat,
•
steam, smoke and hot oil may cause damage�
IMPORTANT
DO NOT install water controllers outdoors unless protection from water / dust ingress and
•
sunlight are provided�
The MC100V water controller MUST NOT be installed in a bathroom�
•
•
DO NOT install water controllers in direct sunlight�
DO NOT install wireless water controllers outdoors unless protection from dust ingress and
•
sunlight are provided�
DO NOT install water controllers against a metal wall unless the wall is earthed in accordance
•
with AN/NZS 3000�
•
Water controllers MUST NOT be installed where chemicals such as benzene, alcohol,
turpentine, hydrogen sulphide, ammonia, chlorine or other similar chemicals are in use�
The Water controller is a water resistant device, however excessive exposure to water may result
in damage to the water controller� Durability is improved when positioned outside the shower
recess�
AVOID direct exposure to water or steam as these conditions may cause a malfunction�
•
•
Water controllers must be installed in shaded and clean locations. They should be fitted out
of reach of children (suggested height from floor to be at least 1500 mm). Water controllers
MUST BE installed at least 400 mm above the highest part of a sink, basin or bath�
When cleaning your water controller use ONLY a damp cloth and a mild detergent�
•
For all water controller dimensions refer to "Dimensions" on page 17�
ADDITIONAL WATER CONTROLLER MOUNTING CONSIDERATIONS.
The MC-100V uses a Liquid Crystal Display (LCD) for the digital monitor�
NOTE
Light reflections can make the LCD difficult to see at direct eye level.
For best results when Installing the MC-100V mount the remote controller
lower than your eye-level to avoid these light reflections.
Rinnai
14
HW_CF OIM