Weider 831.159833 User Manual page 29

Slack can be removed from the Press Cable (72) by
moving the "V"-pulley (34) attached to the Press Seat
Frame (12) closer to the Press Upright (5).
Remove the M10 x 93mm Bolt (85), M10 Washer
(97), and M10 Nylon Locknut (90) from the Press
Seat Frame (12), the "V"-pulley (34), and the Long
Cable Trap (37). Move the "V"-pulley to a hole that is
closer to the Press Upright (5), one hole at a time,
until the slack is removed. Reattach the "V"-pulley
and Cable Trap to the hole with the Bolt, Washer, and
Locknut.
If there is still slack in the Press Cable (72), move the
"V"-pulley (34) attached to the small tube on the
Press Upright (5) to a hole that is closer to the
Upright.
Remove the M10 x 69mm Bolt (92), M10 Washer
(97), and M10 Nylon Locknut (90) from the Press
Upright (5), the "V"-pulley (34), and the Long Cable
Trap (37). Move the "V"-pulley to a hole that is closer
to the Press Upright, one hole at a time, until the
slack is removed. Reattach the "V"-pulley and Cable
Trap to the hole with the Bolt, Washer, and Locknut.
If a cable slips off the pulleys often, the cable may have become twisted. Remove the cable and re-install
it. If the cables need to be replaced, see ORDERING REPLACEMENT PARTS on the back cover of this manual.
12
72
90
97
37
34
72
29
85
97
37
34
90
5
92
5