Weider 831.159833 User Manual page 18

41. Locate the Weight Plate (48) that is attached
to the bottom of the Bottom Weight (47).
See the inset drawing. Attach the end of the Ab
Cable (74) to the bottom of the Weight Plate (48)
with an M10 x 45mm Bolt (94) and an M10 Nylon
Locknut (90).
42. Identify the Low Cable (71). It is approximately
135" long and it has a ball on one end and an eye-
let on the other. Route the eyelet end through the
slot in the cable guide on the Butterfly Base (1).
Route the Low Cable (71) under a 90mm Pulley
(35). Attach the Pulley and a Cable Trap (38) to
the bracket on the Butterfly Base (1) with an M10
x 48mm Bolt (93) and an M10 Nylon Locknut
(90). Make sure the Cable Trap is positioned to
hold the Cable in the groove of the Pulley.
43. Wrap the Low Cable (71) under a 90mm Pulley
(35). Attach the Pulley and a Cable Trap (38) to
the welded tube on the Butterfly Upright (4) with
an M10 x 121mm Bolt (102) and an M10 Nylon
Locknut (90). Note: Thread the Locknut only
two turns onto the Bolt, another Pulley will be
attached to the Bolt in step 45. Make sure the
Cable Trap is positioned to hold the Cable in
the groove of the Pulley.
44. Wrap the Low Cable (71) over a 90mm Pulley
(35). Attach the Pulley and a Cable Trap (38) to
the second set of holes from the bottom in the
Pulley Plates (32) with an M10 x 48mm Bolt (93)
and an M10 Nylon Locknut (90). Make sure the
Cable Trap is positioned to hold the Cable in
the groove of the Pulley.
41
90
48
94
74
42
93
35
71
Cable
Guide
43
44
32
90
38
18
47
38
90
1
102
35
71 38
90
4
93
35
71