Weider 831.159833 User Manual page 22

57. Remove the M10 Nylon Locknut (90) used in
step 53.
Route the Press Cable (72) through the Press
Frame (17).
Wrap the Press Cable (72) under a 90mm Pulley
(35). Slide a Cable Trap (38) and the Pulley onto
the M10 x 121mm Bolt (102) in the bottom of the
Press Upright (5). Properly tighten the M10 Nylon
Locknut (90) onto the Bolt. Make sure the Cable
Trap is positioned to hold the Cable in the
groove of the Pulley.
58. Wrap the Press Cable (72) around a 90mm Pulley
(35) as shown. Slide a Cable Trap (38) and the
Pulley onto the M10 x 92mm Carriage Bolt (112)
in the Press Base (3). Secure the Pulley with an
M10 Nylon Locknut (90). Make sure the Cable
Trap is positioned to hold the Cable in the
groove of the Pulley.
59. Lay the Press Cable (72) in the bracket on the
Center Base (2). Attach a 90mm Pulley (35)
inside the bracket with an M10 x 45mm Bolt (94)
and an M10 Nylon Locknut (90).
60. Wrap the Press Cable (72) over a 115mm Pulley
(36). Attach the Pulley inside the indicated bracket
on the Center Top Frame (8) with an M10 x 45mm
Bolt (94) and an M10 Nylon Locknut (90).
57
58
59
72
60
22
5
102 90
35
17
72 90
35
38
112
3
35
94
90
2
72
90
8
36
94
38
72