Weider 831.159380 User Manual page 18

38. Locate the Leg Press Cable (99). Attach the
end of the Leg Press Cable to the Long "U"-
Bracket (57) with a 1/4" Nylon Locknut (2) and
a 1/4" Flat Washer (10). Do not completely
tighten the Nylon Locknut. It should be
threaded onto the end of the Cable only a
couple of turns, as shown in the inset
drawing.
Wrap the Leg Press Cable (99) around a
3 1/2" Pulley (15). Attach the Pulley to the Leg
Press Upright (56) with the 3/8" x 3 3/4" Bolt
(88), a 3/8" Flat Washer (9), and a 3/8" Nylon
Locknut (21). The ball on the Cable must be
on the indicated side of the Pulley. Be sure
that the Cable and Pulley move smoothly
and that the Cable is between the Pulley
and the welded rod.
39. Attach the Press Bracket (94) to the Leg
Press Arm (96) with a 5/16" x 3" Bolt (111)
and a 5/16" Nylon Locknut (3).
Wrap the Leg Press Cable (99) around a 3 1/2"
Pulley (15). Attach the Pulley to the Press
Bracket (94) with the 3/8" x 2" Bolt (12) and a
3/8" Nylon Locknut (21).
Slide a 5/16" Flat Washer (8) onto a 5/16" x
2 3/4" Bolt (11). Insert the Bolt through the
lowest hole in the Rear Seat Frame (100)
from the indicated side. (Note: The three holes
are for cable adjustment.) Tighten a 5/16"
Nylon Jam Nut (93) onto the Bolt. Slide the
end of the Leg Press Cable (99) onto the end
of the Bolt. Thread another 5/16" Nylon Jam
Nut onto the Bolt. Do not fully tighten the
second Jam Nut. There must be room
between the two Jam Nuts for the end of
the Cable to pivot.
38
10
2
10
57
99
39
11
8
99
100
18
2
57
99
56
88
15
Welded
Rod
96
12
3
94
111
15
21
93
Ball
9
21