Club Weider 16.8ST User Manual page 16

32. Locate the Low Cable (72), which is the only remain-
ing Cable. Note that it has a large ball on one end
and a small ball on the other.
Route the small ball on the Low Cable (72) through
the indicated slots in the Leg Lever (29) and the front
leg on the Base (8).
Attach a 4Ó Pulley (35) inside the slot in the front leg
of the Base (8) with a 3/8Ó x 2 1/2Ó Bolt (54), two 3/8Ó
Flat Washers (55), two 5/8Ó x 1/2Ó Pulley Bushings
(42), and a 3/8Ó Nylon Jam Nut (63).
33. Attach a 4Ó Pulley (35) inside the slot in the Leg Lever
(29) with a 3/8Ó x 2 1/2Ó Bolt (54), two 3/8Ó Flat
Washers (55), two 5/8Ó x 1/2Ó Pulley Bushings (42),
and a 3/8Ó Nylon Jam Nut (63).
Attach the 1/2Ó x 1 3/4Ó Bushing (94) inside the bot-
tom of the Leg Lever (29) with a 5/16Ó x 2 1/2Ó Bolt
(96), two 5/16Ó Flat Washers (80), and a 5/16Ó Nylon
Jam Nut (79).
Refer to the inset drawing. Press the Tab (93) onto
the cage as shown. Secure the Tab with a 1/4Ó x 1Ó
Bolt (95), a Large Washer (104), and a 1/4Ó Nylon
Locknut (25). Make sure that the Low Cable (72) is
on top of the Tab and the 1/2Ó x 1 3/4Ó Bushing (94).
Press a 2Ó Square Inner Cap (33) into the bottom of
the Leg Lever (29). Note: It may be easier to attach
the 2Ó Square Inner Cap and the 1/2Ó x 1 3/4Ó
Bushing (94) if you pivot the Leg Lever upward.
34. Route the Low Cable (72) through the indicated slot
in the Main Upright (3) and the Base (8).
Wrap the Low Cable (72) around a 4Ó Pulley (35) in
the direction shown. Attach the Pulley inside the weld-
ed bracket on the Main Upright (3) with a 3/8Ó x 2Ó
Bolt (62) and a 3/8Ó Nylon Locknut (50) as shown.
35. Wrap the Low Cable (72) over a 4Ó Pulley (35). Slide
the Pulley and a Cable Trap (44) between the two
Pulley Plates (31). Make sure the Cable is in the
groove of the Pulley and that the Cable Trap is
oriented so it will hold the Cable in place.
Attach the 4Ó Pulley (35) and the Cable Trap (44) to
the lowest holes in the Pulley Plates (31) with a 3/8Ó x
1 3/4Ó Bolt (60) and a 3/8Ó Nylon Jam Nut (63).
32
72
35
8
42
Slots
63 55
33
80
42
55
63
79
33
34
35
31
Adjustment
Holes
60
72
16
29
42
55
Large Ball
29
54
Slot
55
42
35
Cage
96
72
94
93
35
62
3
72
50
Bracket
63
44
35
54
72
95
104
25
Slot
8