Cable Assembly - Club Weider 16.8ST User Manual

Cable Assembly

15. Open the parts bags labeled ÒCABLE ASSEMBLYÓ
and Ò4 PULLEYS.Ó Refer to the Cable Diagram on
page 21 as you assemble the cables.
Identify the Leg Press Cable (76) by referring to
page 21. Attach the Leg Press Cable to the indicated
hole in the Leg Press Base (84) with a 3/8Ó x 3Ó Bolt
(45), two 3/8Ó Flat Washers (55), a 5/8Ó x 1/4Ó
Bushing (90), and a 3/8Ó Nylon Jam Nut (63).
16. Wrap the Leg Press Cable (76) up around a 4Ó Pulley
(35). Attach the Pulley and a Cable Trap (44) to the
Rear Press Upright (97) with a 3/8Ó x 3 3/4Ó Bolt (92),
a 3/8Ó Flat Washer (55), and a 3/8Ó Nylon Locknut
(50).
Be sure that the Cable (76) is routed in the direc-
tion shown, and that the Cable Trap (44) is posi-
tioned to hold the Cable in the pulley groove.
17. Wrap the Leg Press Cable (76) under a 4Ó Pulley
(35). Attach the Pulley and a Cable Trap (44) to the
Leg Press Base (84) with a 3/8Ó x 3 3/4Ó Bolt (92), a
3/8Ó Flat Washer (55), and a 3/8Ó Nylon Locknut (50).
Be sure that the Cable (76) is routed in the direc-
tion shown, and that the Cable Trap (44)is posi-
tioned to hold the Cable in the pulley groove.
18. Wrap the Leg Press Cable (76) around a 4Ó Pulley
(35). Attach the Pulley and a Cable Trap (44) to the
3/8Ó x 5Ó Carriage Bolt (82) in the Stabilizer (5) with a
3/8Ó Nylon Locknut (50).
Be sure that the Cable (76) is routed in the direc-
tion shown, and that the Cable Trap (44)is posi-
tioned to hold the Cable in the pulley groove.
15
55
45
16
55
50
97
17
84
50
55
18
50
35
44
76
82
5
11
63
90
55
76
84
92
35
44
76
92
35
44
76