Firstech FTI-FDK1 Manual

FTI-FDK1 Type 1C4 - Vehicle Coverage & Preparation Notes
Make Model
DL-FM2
Ford Fiesta
Hey! Read this stuff before you start the installation...
Firmware:
Covered vehicle uses BLADE-AL(DL)-FM2 firmware, flash module and update the controller firmware before installing.
Controller Configuration:
Set feature 1-11 to option 2 (Ignition pulse - same timing as disarm pulse) for proper handling of OEM alarm.
Door Locks:
Fiesta door locks are controlled by a single wire . Unlock is controlled by supplying a ( - ) negative pulse to the vehicle wire
(pin #8, brown/white, white 24-pin BCM connector), Lock is controlled by presenting an open circuit condition to the same wire.
See diagram below or in installation guide for detailed connection instructions.
Parking Lights:
Parking lights ( - ) negative: yellow/blue, pin #2 at headlight switch.
Lights-off (open): white/violet, pin #6 at headlight switch.
Okay, now get to work...
Year
2011-13
Headlight Switch Connector
yellow/blue
6
white/violet
30
87a
+12V
87
PK LIGHTS
( - )
Install CAN
Park / Auto
Type 1 OBD-II C
2 5
10
SUPPORT - 1(888) 820-3690, EXT. 203
Lights
RAP Trunk
+12V
30
LOCK
87a
UNLOCK
87
CM7000/7200
CM900AS/900S Jumper
I/O Changes
Green White/Blue
Cut loop for A/T
CM-900S/900AS