Juniper ACX710 Quick Start Manual page 6

Figure 5: Install the Mounting Rails on an ACX710 Router
4. Using a Phillips (+) number 2 screwdriver, secure the mounting rails to the chassis using the mounting screws.
5. With one person on each side, hold on to the bottom of the chassis, and carefully lift the chassis so that the mounting
rails are aligned with the rack rails.
6. Carefully slide the chassis with the rails attached on to the rack rails (see
Figure 6: Install the ACX710 Router in a Four-Post Rack
7. Install mounting screws into each of the front-mounting bracket holes aligned with the rack, starting from the bottom,
and tighten the screws.
8. Align the holes in the cable bar with the holes at the top of the mounting bracket, and tighten the screws to attach the
cable bar.
Figure 7: Install the Cable Bar
9. Visually inspect the alignment of the chassis.
Figure 6).
6