Manual Lighting; To Extinguish - Weber SUMMIT 400 Operating Manual

MANUAL LIGHTING

EACH HEAT ZONE OPERATES INDEPENDENTLY.
Summary lighting instructions are on the control panel
High Medium
DA N G E R
Failure to open sliding work surfaces while
igniting the barbecue, or not waiting 5 minutes
to allow the gas to clear if the barbecue does not
light, may result in an explosive flame-up which
can cause serious bodily injury or death.
1) Open the sliding work surfaces and splash guards.
Figure 2.
2) Make sure all burner control knobs are turned OFF.
(Push each burner control knob down and turn
clockwise.)
Manual Lighting
Summit 400
Manual Lighting
Summit 600
Low Off
Figure 2
3) Turn on gas supply.
4) Select Heat Zone.
5) Put a match in the match holder and strike the match.
6) Push LEFT burner control knob down and turn to
H (high).
WARNING: Do not lean over open barbecue. Keep
your face and body at least one foot away from the
matchlight hole when lighting the barbecue.
7) Insert match holder and lit match through matchlight
hole to ignite LEFT burner. Figure 3.
Control panel
8) Observe if LEFT burner has ignited by looking
through matchlight hole.
WARNING: If LEFT burner fails to ignite turn LEFT
burner control knob to OFF and wait 5 minutes before
attempting to ignite again.
9) After the LEFT burner is lit you can turn on the
RIGHT burner.
Note: Always light the LEFT burner first.The RIGHT
burner ignites from the LEFT burner.

TO EXTINGUISH

Turn gas supply OFF at the source, then push down
and turn each burner control knob clockwise to OFF.
7
matchlight hole
in control panel
Hole in cooking
box assembly
Left burner tube
Figure 3