Lighting Instructions; Manual Lighting - Weber 120 Owner's Manual

Lpg
Table of Contents

Advertisement

8
LIGHTING
Summary lighting instructions are on the fold-out work
.
surface (Q120, 200, 220)
1) Open the lid.
2) Unfold the work surfaces (Q120, 200, 220)
3) Make sure the control knob is turned OFF. (Push
control knob in and turn clockwise to ensure that it is
in the OFF position.)
2).
5a).
5b).
Caution: do not fold in tables until grill
(Q120, 200, 220).
is cold
Failure to open the lid while igniting the barbecue's burner, or not waiting 5 minutes to
allow the gas to clear if the barbecue does not light, may result in an explosive flare-up,
which can cause serious bodily injury or even death.

MANUAL LIGHTING

1)
Open the lid.
2)
Unfold the work surfaces (Q120, 200, 220).
3)
Make sure the burner control knob is turned OFF.
Turn the cylinder on by turning the cylinder valve
anticlockwise.
4) Strike a match and put the flame into the matchlight hole
under the igniter.
WARNING: Do not lean over open
barbecue. Keep your face and body
at least 30 cm (12 inches) away from
the matchlight hole when lighting the
barbecue.
5) Push burner control knob in and turn to
START/HI.
6) Check that the burner is lit by looking down through the
cooking grate. You should see a flame.
Caution: do not fold in tables until grill is cold (Q120, 200, 220).

LIGHTING INSTRUCTIONS

LIGHTING INSTRUCTIONS
WARNING: Do not lean over the open
barbecue. Keep your face and body at least
30 cm (12 in) away from the matchlight hole
when lighting the barbecue.
.
Turn the cylinder on by turning the cylinder valve
anticlockwise.
4) Push burner control knob in and turn to START/HI.
5a)
Push the red ignition button several times, so it
clicks each time (Q100, 200).
1).
6).
2).
DANGER
WARNING: If the burner does not light,
turn the burner control knob to OFF
and wait 5 minutes to let the gas clear
before you try again or before you try to
light with a match.
4).
START/
HI
3).
OFF
5b)
Push the electronic ignition button several times.
You will hear it spark (Q120, 220).
6) Check that the burner is lit by looking down through
the cooking grate. You should see a flame.
WARNING: If the burner does not light, turn
the burner control knob to OFF and wait
5 minutes to let the gas clear before you
try again or before you try to light with a
match.
A
A. - LOW
B
B. - MED.
C. - START/
C
HIGH
D. - OFF
D
To Extinguish:
Push in and turn burner control
knob clockwise to the OFF
position.
2).
4).
1).
6).
2).

Advertisement

Table of Contents
loading

This manual is also suitable for:

100200220

Table of Contents