Chapter 10
Cisco S690 Web Security Appliance
Figure 10-3
1
2
3
4
5
Table 10-1
Front Panel LEDs, Definitions of States
LED Name
1
Hard drive fault
2
Hard drive activity
3
Power button/LED
Cisco S690 Web Security Appliance Front Panel LEDs
Hard drive fault LED
Hard drive activity LED
Power button/power status LED
Identification button/LED
System status LED
State
Off—The hard drive is operating properly.
•
Amber—Drive fault detected.
•
Amber, blinking—The device is rebuilding.
•
Amber, blinking with one-second interval—Drive locate function activated.
•
•
Off—There is no hard drive in the hard drive tray (no access, no fault).
•
Green—The hard drive is ready.
•
Green, blinking—The hard drive is reading or writing data.
Off—There is no AC power to the appliance.
•
Amber—The appliance is in standby power mode. Power is supplied only to the
•
Baseboard Management Controller (BMC) and some motherboard functions
which enable you to use remote power commands.
Green—The appliance is in main power mode. Power is supplied to all appliance
•
components.
Cisco x90 Series Content Security Appliances Installation and Maintenance Guide
Using Status LEDs and Buttons for Maintenance
6
Fan status LED
7
Temperature status LED
8
Power supply status LED
9
Network link activity LED
10-5