Table of Contents
Advertisement
Cisco S190 Web Security Appliance
•
•
•
Rear Panel Ports
Figure 8-1
below has one power supply. It is also available with an optional second power supply.
Figure 8-1
Item
1
2
3
4
5
Rear Panel Ports, page 8-1
Using Status LEDs and Buttons for Maintenance, page 8-2
Summary of Features, page 8-4
shows the rear panel ports of the Cisco S190 Web Security Appliance. The model shown
Cisco S190 Web Security Appliance Rear Panel Ports
Port
Proxy port 1
Proxy port 2
Traffic Monitor
port 1
Traffic Monitor
port 2
RPC
Cisco x90 Series Content Security Appliances Installation and Maintenance Guide
C H A P T E R
Description
Connect proxy port P1 to the network for both
incoming and outgoing traffic.
When both proxy ports P1 and P2 are enabled,
you must connect P1 to the internal network and
P2 to the Internet. P1 and P2 can connect to L4
switch, WCCP router, or network switch.
Traffic monitor port T1 for Duplex Ethernet tap:
One cable for all incoming and outgoing traffic.
Traffic monitor port for Simplex Ethernet tap:
One cable for all packets destined for the
internet (T1), and one cable for all packets
coming from the Internet (T2).
Port that is used for RPC.
8
8-1
Advertisement
Table of Contents
