Table of Contents
Advertisement
Using Status LEDs and Buttons for Maintenance
1
3
5
7
9
Using Status LEDs and Buttons for Maintenance
•
•
Front Panel LEDs
Figure 10-3
The model with 16 drives is shown.
Cisco x90 Series Content Security Appliances Installation and Maintenance Guide
10-4
Management interface 1
Fiber optic interface; management use only
Traffic Monitor port 1
The primary fiber optic port traffic monitor
port T1 for Duplex Ethernet tap: One cable for
all incoming and outgoing traffic.
Proxy port 1
The primary fiber optic port used to connect
proxy port P1 to the network for both
incoming and outgoing traffic.
RPC
Data
1-Gigabit Ethernet customer data interface
Front Panel LEDs, page 10-4
Rear Panel LEDs and Buttons, page 10-6
shows the front panel LEDs.
Chapter 10
2
Management interface 2
Fiber optic interface; management use only
4
Traffic Monitor port 2
Traffic monitor port for Simplex Ethernet tap:
One cable for all packets destined for the
internet (T1), and one cable for all packets
coming from the Internet (T2).
6
Proxy port 2
When both proxy ports P1 and P2 are enabled,
you must connect P1 to the internal network
and P2 to the Internet. P1 and P2 can connect
to L4 switch, WCCP router, or network
switch.
8
Console
Directly connects a computer to the appliance
10 Management interface 3
1-Gigabit Ethernet management port; not in
use
Table 10-1
defines the LED states.
Cisco S690 Web Security Appliance
Advertisement
Table of Contents
