Table of Contents
Advertisement
Chapter 5
Cisco M190 Content Security Management Appliance
Table 5-1
Front Panel LEDs, Definitions of States (continued)
LED Name
3
Power button/LED
4
Unit identification
5
System status
6
Fan status
7
Temperature status
8
Power supply status
9
Network link activity
State
Off—There is no AC power to the appliance.
•
Amber—The appliance is in standby power mode. Power is supplied only to the
•
Baseboard Management Controller (BMC) and some motherboard functions which
enable you to use remote power commands.
Green—The appliance is in main power mode. Power is supplied to all appliance
•
components.
Off—The unit identification function is not in use.
•
Blue—The unit identification function is activated.
•
Green—The appliance is running in normal operating condition.
•
Green, flashing—The appliance is performing system initialization and memory
•
check.
Amber—The appliance is in a degraded operational state. For example:
•
Power supply redundancy is lost.
–
CPUs are mismatched.
–
At least one CPU is faulty.
–
At least one DIMM is faulty.
–
–
At least one drive in a RAID configuration failed.
•
Amber, flashing—The appliance is in a critical fault state. For example:
–
Boot failed.
Fatal CPU and/or bus error is detected.
–
The appliance is in an over-temperature condition.
–
Green—All fan modules are operating properly.
•
Amber—One or more fan modules breached the critical threshold.
•
Amber, flashing—One or more fan modules breached the non-recoverable
•
threshold.
Green—The appliance is operating at normal temperature.
•
Amber, steady—One or more temperature sensors breached the critical threshold.
•
Amber, blinking—One or more temperature sensors breached the non-recoverable
•
threshold.
•
Green—All power supplies are operating normally.
•
Amber—One or more power supplies are in a degraded operational state.
•
Amber, flashing—One or more power supplies are in a critical fault state.
Off—The Ethernet link is idle.
•
Green—One or more Ethernet LOM ports are link-active, but there is no activity.
•
Green, flashing—One or more Ethernet LOM ports are link-active, with activity.
•
Cisco x90 Series Content Security Appliances Installation and Maintenance Guide
Status LEDs and Buttons for Maintenance
5-3
Advertisement
Table of Contents
