Table of Contents
Advertisement
Rear Panel Ports
Rear Panel Ports
The Cisco S690 Web Security Appliance is available with either Ethernet ports or Fiber Optic ports. The
description of these ports are described in separate sections below.
Models with Ethernet Ports
The S690 and S690X models of the Cisco Web Security Appliance have Ethernet ports.
Figure 10-1
For more information about rear panel LEDs, see
Figure 10-1
1
3
5
7
Models with Fiber Optic Ports
The S690-1G and S690-10G models of the Cisco Web Security Appliance have Fiber Optic ports.
Cisco x90 Series Content Security Appliances Installation and Maintenance Guide
10-2
shows the rear panel ports of the Cisco S690 Web Security Appliance with Ethernet ports.
Rear Panel Ports of Cisco S690 Web Security Appliances
Proxy port 1
Connect proxy port P1 to the network for both
incoming and outgoing traffic.
Traffic monitor port 1
Traffic monitor port T1 for Duplex Ethernet
tap: One cable for all incoming and outgoing
traffic.
RPC
Management interface 1
1-Gigabit Ethernet interface; management use
only
Chapter 10
Cisco S690 Web Security Appliance
Rear Panel LEDs and Buttons, page
2
Proxy port 2
When both proxy ports P1 and P2 are enabled,
you must connect P1 to the internal network
and P2 to the Internet. P1 and P2 can connect
to L4 switch, WCCP router, or network
switch.
4
Traffic monitor port 2
Traffic monitor port for Simplex Ethernet tap:
One cable for all packets destined for the
internet (T1), and one cable for all packets
coming from the Internet (T2).
6
Console
Directly connects a computer to the appliance
8
Management interface 2
The secondary Management port; not in use
10-6.
Advertisement
Table of Contents
