Table of Contents
Advertisement
Erratum
Note. Before performing this loading operation, ensure the tape
threading is free from residual paper.
HOW ? After having raised the cover lid, carry out steps as shown
in the photos :
1 - cut the tape above the TAPE PUNCH,
- depress m RUN OUT key until complete tape disenga
gement,
- pull tape support completely towards you, then disengage
the used roll,
2 install a new roll in such a way that the tape unwinds up and
towards you. Insert the tape under the tape tension lever (see
threading diagram on the cover) then press the support to the
stop,
3 release the PUNCH tape pressure plate (red mark visible) and
insert the tape until it passes freely through,
4 depress tape pressure plate until it locks. A distinct click can
be heard (red mark not visible),
5 depress LiJ RUN-OUT key in order to check the correct
threading.
: : : J | .
iU'mW-VMmf
|K9K ||PMft ^mmm tm^mt p^^* •
Advertisement
Table of Contents
