Failover And Recovery Registration; Rfc3311; Sip Notify Xml-Service - Cisco 7800 Series Administration Manual

Dual Registration and Alternate Proxy
• Do not use Dual Registration along with other Fallback or Recovery mechanisms. For example: Broadsoft
• There is no recovery mechanism for feature request. However, the administrator can adjust the
Dual Registration and Alternate Proxy
When the Dual Register parameter is set to No, Alternate Proxy is ignored.

Failover and Recovery Registration

• Failover—The phone performs a failover when transport timeout/failure or TCP connection failures; if
• Recovery—The phone attempts to reregister with the primary proxy while registered or actively connected
Fallback Behavior
The fallback occurs when the current registration expires or Proxy Fallback Intvl fires.
If the Proxy Fallback Intvl is exceeded, all the new SIP messages go to primary proxy.
For example, when the value for Register Expires is 3600 seconds and Proxy Fallback Intvl is 600 seconds,
the fallback triggers 600 seconds later.
When the value for Register Expires is 800 seconds and Proxy Fallback Intvl is 1000 seconds, the fallback
triggers at 800 seconds.
After successful registration back to the primary server, all SIP messages go to the primary server.

RFC3311

The Cisco IP Phone supports RFC-3311, the SIP UPDATE Method.

SIP NOTIFY XML-Service

The Cisco IP Phone supports the SIP NOTIFY XML-Service event. On receipt of a SIP NOTIFY message
with an XML-Service event, the phone challenges the NOTIFY with a 401 response if the message does not
contain correct credentials. The client must furnish the correct credentials using MD5 digest with the SIP
account password for the corresponding line of the IP phone.
The body of the message can contain the XML event Message. For example:
<CiscoIPPhoneExecute>
<ExecuteItem Priority="0" URL="http://xmlserver.com/event.xml"/>
</CiscoIPPhoneExecute>
Authentication:
challenge
":" MD5(A2) )
Cisco IP Phone 7800 Series Multiplatform Phones Administration Guide
54
mechanism.
reregistration time for a prompt update of the registration state for primary and alternate proxy.
Try Backup RSC and Retry Reg RSC values are datafilled.
to the secondary proxy.
Auto register when failover parameter controls the failover behavior when there is an error. When this
parameter is set to yes, the phone re-registers upon failover or recovery.
= MD5( MD5(A1) ":" nonce ":" nc-value ":" cnonce ":" qop-value
Cisco IP Phone Installation