Troubleshooting Guide; Blower And Battery - Stihl BGA 86 Instruction Manual

Hide thumbs Also See for BGA 86:
Table of Contents

Advertisement

Available languages

Available languages

English

23 Troubleshooting Guide

23.1 Blower and Battery

Always remove the battery before carrying out any inspection, cleaning or maintenance.
Condition
LEDs on
Battery
Blower does not start
when switched on.
1 LED flashes
green.
STIHL AR
Series: four
long beeps are
emitted (AR L -
six beeps).
1 LED glows
red.
4 LEDs flash
red.
STIHL
AR Series:
Additionally, a
rapid
succession of
short beeps is
emitted.
3 LEDs glow
red.
3 LEDs flash
red.
26
Cause
Remedy
No electrical contact
► Remove the battery, @ 14.2.
between blower and
► Visually check the electrical contacts in the battery
battery.
compartment and on the battery.
► Reinsert the battery, @ 14.1.
Battery has low
► Charge the battery, @ 10.
charge.
Battery too hot / too
► Allow the battery to warm up or cool down gradually at
cold.
ambient temperatures of about 50 °F to 68 °F (10 °C to
20 °C).
Malfunction in
► Remove the battery and reinsert it, @ 14.
battery.
► Switch on the blower, @ 15.1.
► If the LEDs continue to flash, do not attempt to use.
The battery has a malfunction and must be replaced.
Blower too hot.
► Allow the blower to cool down.
Malfunction in
► Remove the battery and reinsert it, @ 14
blower.
► Switch on the blower, @ 15.1.
► If the LEDs still flash, do not attempt to use.
The blower has a malfunction and must be checked by a
servicing dealer.
23 Troubleshooting Guide
0458-824-8621-B

Advertisement

Chapters

Table of Contents
loading

Table of Contents