Suzuki Baleno Manual page 64

BEFORE DRIVING
EXAMPLE
4) Grasp the front of the child restraint and
push the child restraint forcefully to
latch the connecting bars. Check that
they are securely latched by trying to
move the child restraint system in all
directions, especially forward.
5) Attach the top tether strap referring to
"Installation of child restraint with top
tether" section below.
When you put your child in the child
restraint system, appropriately slide the
front seat forward not to touch a part of
your child's body.
NOTICE
When installing a child restraint sys-
tem to the rear seat, adjust the front
seat position so that the front seat
does not interfere with the child
restraint system.
2-45
Installation of child restraint with
top tether
Front
54G185
Some child restraint systems require the
use of a top tether strap. Top tether anchor-
age brackets are provided in your vehicle at
the locations shown in the illustrations.
The number of the top tether anchorage
brackets provided in your vehicle depends
on the vehicle specification. Install the child
restraint system as follows:
1) Remove the luggage compartment cover
(if equipped).
2) Secure the child restraint on the rear
seat using the procedure described
above for securing a restraint system
EXAMPLE
that does not require a top tether strap.
3) Hook the top tether strap to the top
tether anchorage bracket and tighten
the top tether strap according to the
instructions provided by the child
restraint system manufacturer. Attach
the top tether strap to the correspond-
ing top tether
located directly
restraint. Do not attach the top tether
strap to the luggage restraint loops (if
equipped).
68PM00247
WARNING
Do not attach the child restraint top
tether strap to the luggage restraint
loops (if equipped).
attached top tether strap will reduce
the intended effectiveness of the
child restraint system.
anchorage bracket
behind the child
Incorrectly
68PM2-01E