Table of Contents
Advertisement
Cooking zone timer (1 to 99 minutes):
When the hob is switched on, an independent timer can be
programmed for each cooking zone.
Select a cooking zone, then select the temperature setting
and, finally, activate the timer setting button (5), the timer
can be programmed to switch off a cooking zone.
Four LEDs are arranged around the timer that indicate which
cooking zone the timer has been set for. 10 seconds after the
last operation, the timer display will change to the timer that
will run out next (in cases where a timer is set for more than
one cooking zone). When the timer has run down, a signal
will sound, the timer display will show "00" and the assigned
cooking zone timer LED will blink. The programmed cooking
zone will switch off and "H" will be displayed if the cooking
zone is hot.
The sound signal and the blinking of the timer LED will stop
automatically after 2 minutes and/or by pressing any button.
Buzzer
While the hob is in operation, the following activities will be
signalled by the buzzer.
• Normal button activation will be accompanied with a
short sound signal.
• Continuous button operation over a longer period of
time (10 seconds) will be accompanied with a longer,
intermittent sound signal.
Boost Function
This function allows for rapid heating on the selected zone.
Once the selected zone has reached the required cooking
temperature the power level will reduce automatically to the
preset level.
To activate the pre-heat function
1.
Select the required cooking zone with a boost function
and set the desired cooking zone.
2.
Press the P (11) button once more. 'P' will show in the
display (Fig. 2.5).
3.
Activating the booster may cause the requested power
to exceed the maximum possible power and the power
management to become active.
4.
A necessary power reduction of the other cooking zone
of the same induction system is indicated to the user by
the allocated display flashing; it offers a correction time
of 3 sec. before the power reduction to the necessary
reduced power level (cooking stage) takes place. The
boost function has a time limit in the system.
The power density during boost mode may be too high when
heating oil, e.g. deep fat frying, and the base of the pot may
overheat. To achieve maximum system performance, you
must not use the boost function heat oil.
9
Advertisement
Table of Contents
