Residual Heat Indicator, 'H - Rangemaster Eclipse 60 User Manual & Installation & Service Instructions

Switching the appliance off:
1. Switch the hob off at any time by pressing ON/OFF key
(1). The ON/OFF (1) key always has priority in the switch
off function.
Switching the cooking-zones on:
Now element is ready to use. For fast boil times, select the
desired cooking level, then press the "P" button to activate
the Boost function
Switching the Cooking Zones Off
Press the heater selection button that corresponds to the
heater you wish to use.
A static dot will be shown on the selected heater display and
the blinking dots on all other heater displays will no longer
illuminate.
For the selected heater, you can set the heat level by pressing
the Sliding Button (9). The element is now ready to use. For
fast boil times, select the desired cooking level, then press the
"P" button to activate the Boost function.
Switching ALL Cooking Zones Off
To switch all the cooking zones off at once, press the ON/OFF
(11) button
In the stand-by mode, a "H" will appear on all cooking zones
which are hot.

Residual Heat Indicator, 'H'

After use, a cooking zone will remain hot for a while as heat
dissipates. When a cooking zone is switched off the residual
heat indicator symbol 'H' , will appear in the display. This shows
that the cooking zone temperature is above 60°C and may
still cause burns. Once the temperature has dropped to below
60°C the 'H' will go out.
Smart Pause (2)
Smart Pause (2), when activated, reduces the power of all
burners that have been switched on.
If you then deactivate the Smart Pause (2), the heaters will
automatically return to the previous temperature level.
If the Smart Pause (2) is not de-activated, the cooktop will
switch off after 30 minutes.
Press the Smart Pause (2) button to activate. The power for
the activated heater(s) will reduce to level 1 and the Pause
symbol "II" will appear on all displays.
Press again to deactivate Smart Pause (2). The Pause symbol
"II" will disappear and the heaters will now run at the level
previously set.
Safety Switch-Off Function
A cooking zone will automatically switch off if the heat
setting has not been modified for a specified duration of
time. A change in the heat setting of the cooking zone will
reset the time duration to the initial value. This initial value
depends on the selected temperature level, as shown below.
Heat setting
1-2
3-4
5
6-9
7
Safety switch off after
6 hours
5 hours
4 hours
1.5 hours