Unpacking - Superior Fireplaces Custom Series Installation And Operation Instructions Manual

UNPACKING

The following items are packed inside the fi rebox. Remove before
positioning fi rebox into framing.
• Transition Collar - For vent connection
• Ceramic Log Pack - Shrink-wrapped on cardboard
• Three (3) plastic bags containing volcanic stone, pan and ember
materials
• Rear Log - Remove the two plastic quick ties from around the
burner and grate
• Grate Stand - Lift off of burner pan
Check all items for any shipping damage. If damaged, promptly inform
dealer or distributor where you bought the product.
Safely retain these items for later installation.
All 36" and 42" models listed within this manual are vented gas fi replaces
that use a millivolt control valve and piezo ignition system. A 6" B-Type
venting system and a listed type vent cap are not supplied but are required
for proper operation. See venting instructions on Pages 9 and 10.
WARNING: This gas appliance must not be con-
nected to a chimney fl ue serving a separate solid-fuel
burning appliance.
Models BRT4036TMN-B, 4336TMN-B, 4536TMN-B, 4042TMN-B,
4342TMN-B, 4542TMN-B, 4036TMP-B, 4336TMP-B, 4536TMP-B,
4042TMP-B, 4342TMP-B, 4542TMP-B are vented gas fi replaces that
use a millivolt gas control valve with a millivolt ignition system. A 6"
B-Type venting system and a listed type vent cap are not supplied
but are required for proper operation. See venting instructions on
Pages 9 and 10.
4
BEFORE YOU BEGIN
Before beginning the installation of your appliance, read these
instructions through completely.
This INNOVATIVE HEARTH PRODUCTS, LLC (IHP) appliance and
its approved components are safe when installed according to this
installation manual and are operated as recommended by IHP. Un-
less you use IHP approved components tested for this appliance,
YOU MAY CAUSE A FIRE HAZARD!
The IHP warranty will be voided by and IHP disclaims any respon-
sibility for the following actions :
A) Modifi cation of the appliance or any of the components.
B) Use of any component part not approved by IHP in combination
with this appliance.
C) Installation and/or operation in a manner other than instructed
in this manual.
D) Burning of anything other than the type of gas approved for use
in this gas appliance.
The installation must conform with local codes or, in the absence of local
codes, with the current National Fuel Gas Code, ANSI Z223.1/NFPA 54,
or the Natural Gas and Propane Installation Code, CSA B149.1.
This fi replace complies with the National Safety Standards and is
listed and tested by PFS Corporation to ANSI Z21.50/CSA 2.22
standard as vented gas fi replace.
SuperiorFireplaces.US.com 900806-00NC