Install The Edge Switch On A Desktop - HP StorageWorks Edge Switch 2/12 Installation Manual

Install the Edge Switch on a Desktop

To install and configure the Edge Switch on a desktop:
1. Remove the backing from the three adhesive rubber pads and apply the pads
2. Position the Edge Switch on a table or desktop. Ensure that:
3. Verify all field-replaceable units (FRUs), small form factor pluggable (SFP)
4. Connect the U.S.- or country-specific (optional) AC power cord receptacle at
5. Connect the AC power cord to a facility power source that provides
Edge Switch 2/12 Installation Guide
to the underside of the Edge Switch. Ensure the pads are aligned with the
scribed circles at each corner and in the middle of the Edge Switch.
— Grounded AC electrical outlets are available.
— Adequate ventilation is present.
— Areas with excessive heat, dust, or moisture are avoided.
— All planning considerations are met. Refer to the HP StorageWorks
HA-Fabric Manager User Guide.
optical transceivers, are installed as ordered.
the rear of the chassis.
WARNING: An HP-supplied power cord is provided for the Edge Switch
power supply. To prevent electric shock when connecting the Edge Switch to
primary facility power, use only the supplied power cord and ensure that the
facility power receptacle is the correct type, supplies the required voltage,
and is properly grounded.
single-phase, 100 to 240 volt alternating current (VAC).
When the power cord is connected, the Edge Switch powers on and performs
power-on self-test (POST). During POST:
— The green power (PWR) LED on the front panel illuminates.
— The amber system error (ERR) LED on the front panel blinks
momentarily while the Edge Switch is tested.
— The green LEDs associated with the Ethernet port blink momentarily
while the port is tested.
— The green/blue and amber LEDs associated with Fibre Channel ports
blink momentarily while the ports are tested.
Installing and Configuring the Edge Switch 2/12
33