Exmark LAZER Z PROPANE Operator's Manual page 28

Operation
DANGER
An uncovered discharge opening will allow
objects to be thrown in an operator's or
bystander's direction. Also, contact with the
blade could occur. Thrown objects or blade
contact can cause serious injury or death.
Never operate the mower with the discharge
deflector raised, removed, or altered unless there
is a grass collection system or mulch kit in place
and working properly.
The PTO push-pull switch engages the cutting blades.
Be sure that all persons are clear of the mower deck
and discharge area before engaging PTO.
Important: Operator must be in seat before the
PTO can be engaged.
1. Set the throttle midway between the "SLOW" and
"FAST" positions.
2. Pull the PTO switch outward to engage the blades.
3. Place the throttle in the "FAST" position to begin
mowing.
Disengaging the PTO
1. Set the throttle midway between the "SLOW" and
"FAST" positions.
2. Push the PTO switch in to disengage the blades.
Stopping the Engine
1. Bring the unit to a full stop.
2. Disengage the PTO.
3. Move the motion control levers out to the neutral
lock position.
4. Engage the parking brake.
5. Place the throttle in the "SLOW" position.
6. Turn off the fuel valve and allow the engine to
run out of fuel. Failure to do this may cause the
engine to "flood" when re-starting.
7. Turn the ignition switch to the "OFF" position
once the engine has stopped.
8. Remove the key to prevent children or other
unauthorized persons from starting engine.
Driving the Machine
CAUTION
Machine can spin very rapidly by positioning one
lever too much ahead of the other. Operator may
lose control of the machine, which may cause
damage to the machine or injury.
• Use caution when making turns.
• Slow the machine down before making sharp
turns.
Important: To begin movement (forward or
backward) the operator must be in the seat, the
brake lever must be disengaged (pushed down)
before the motion control levers can be moved in
or the engine will stop.
When the motion control levers are positioned fully
outward (apart) in the T-slot, the drive system is in
the neutral lock position (Figure 13).
Note: The "N" LCD indicator appears when both
levers are in the neutral lock position.
When the motion control levers are moved directly
inward (together) the drive system is in the neutral
operate position.
28