Exmark LAZER Z PROPANE Operator's Manual page 20

Specifications
• Deck Height Adjustment Lever: Sets cutting
height to desired position.
• Deck Lift Pedal: Foot pedal that lifts deck.
• Transport Lock:
– Latching position: Automatically latches at
the transport position.
– Unlatching position: Deck does not latch at
the transport position.
Seat
• Type: Standard seat with high back, extra
wide foam padded seat cushion with internal
suspension, thick bolstering, armrests, integral
safety switch.
Optional seat accessories:
– Custom ride suspension system to enhance
Standard Seat. Adds approximately 3 inches
(7.6 cm) to seat height.
– Deluxe suspension seat with high back, low
profile foam-in-place cushion (dampened,
adjustable spring suspension), armrests, and
integral safety switch. Seat height remains the
same.
– Seat Isolation System for reduced vibration,
to enhance ride of standard seat, standard seat
with Custom Ride Seat Suspension or Deluxe
Suspension Seat. Adds approximately 1 inch
(2.5 cm) to seat height.
• Mounting: Adjustable fore and aft on seat tracks.
– Armrests: Foam padded adjustable flip-up
armrests.
– Seat Safety Switch: Integrated seat switch.
Time delay seat switch eliminates rough
ground cut-outs.
Hydrostatic Ground Drive System
• Two unitized hydrostatic transmissions:
– 12cc Parker axial piston pump
– 240cc Parker geroler motor
• Hydraulic Oil Type: Exmark Premium Hydro oil.
• Hydraulic Oil Capacity: 52 oz (1.5 L) per side
• Hydraulic Filter: P/N 116-0164
• Speeds:
– 0-10 mph (16.1 km/hr) forward.
– 0-5.5 mph (8.9 km/hr) reverse.
• Drive wheel release valves allow machine to be
moved when engine is not running.
Tires & Wheels
Pneumatic (Air
2
Quantity
Tread "Multi-Trac
C/S"
Size 24 x 12.00-12
Ply Rating 4
Pressure 13 psi (90 kPa)
Cutting Deck
• Cutting Width:
– 52 inch Deck: (132.1 cm)
– 60 inch Deck: (152.4 cm)
– 72 inch Deck: (182.9 cm)
• Discharge: Side
• Blade Size: (3 ea.)
– 52 inch Deck: 18.00 inches (45.7 cm)
– 60 inch Deck: 20.50 inches (52.1 cm)
– 72 inch Deck: 24.50 inches (62.2 cm)
• Blade Spindles: Solid steel spindles with 1.00 inch
(25 mm) I.D. bearings.
• Deck Drive:
Electric clutch. Shaft diameter 1.125 inches (2.86
cm)
5V Section belt with self-tensioning idler.
• Deck:
Full floating deck is attached to out-front support
frame. Anti-scalp rollers provide maximum turf
protection. Deck design allows for bagging,
mulching or side discharge.
– 52 inch Deck: 3 anti-scalp rollers
– 60 inch Deck: 4 anti-scalp rollers
– 72 inch Deck: 6 anti-scalp rollers
• Deck Depth:
– 52 inch Deck: 5.5 inches (14 cm)
20
Drive Front Caster
Semi-Pneumatic
filled)
2
Smooth
13 x 6.50-6
—
—