Zoom H4n Pro Operation Manual page 33

EFFECT
TUNER Use tuner
MONITOR Enable monitoring
PHANTOM Enable phantom power
PLUG-IN Enable plug-in power
DISCONNECT End connection
When you select an input the corresponding
turn off the input, press the corresponding
button so the light turns off.
To monitor input signals, you must turn
MONITOR on.
Note: If no input is selected and no input buttons are
lit, no signal is being sent to the computer.
• You cannot change the sampling
the H4n Pro as an audio interface.
• When connecting as an interface,
make sure the sampling rate (step
6) matches the recording software
• You cannot changed this setting
during recording and playback.
Audio interface use
• You can record and playback
signals directly to and from your
DAW software using the H4n Pro.
• In this mode, you can use the
signals if the sampling rate is set
to 44.1kHz.
•
use the H4n Pro as a USB audio
interface.
• When using a DAW or other soft-
ware, refer to its manual.
032