• Check the connections to your monitoring system and its volume setting.
•
created on the H4n Pro. If the remaining capacity of the SD card is low, the
case, end recording standby of the track.
• Check the input source settings. (
• If INPUT 1 or 2 jacks are used, raise the output level of the connected device.
• When the monitor function (
P070) is off, an input signal can only be moni-
tored if its track is set to recording standby or if the recorder is in recording
standby.
• If a project is protected, recording is not possible. Use another project or turn
protection off. (
P125)
P045)
P045)
• If "Card Protected!" appears on the display, the SD card write-protection is
enabled. Slide the write-protection switch on the SD card to disable write-
protection.
Cannot use tuner
input source.
• The operation mode must be set on the H4n Pro to allow the computer to rec-
ognize it. (
P031)
P018)
P033)
150