Table of Contents
Advertisement
Warning Indications
---+~
c:::J
Exhausted
• Appears when an incompatible USB device is connected to
the camera.
• Appears when the connected DVD burner is switched off. If
you want to use the DVD burner, switch the power on.
• The writing speed of recording medium is slow, or the
19
recording medium is corrupted. Use an SO card that is
guaranteed to operate correctly.
• The hard disk was subjected to vibrations or jolts. Be careful
not to subject the hard disk to vibrations or jolts.
• Appears when the recording medium is full and recording
37
is not possible. Delete unnecessary files, or replace the SO
card.
• Appears when the event information cannot be read.
40
Register the file to an event.
• The video management file is broken. Recovery is required
to record or play back video files. Move the set lever to
A /
v to select [YES], then press down to recover the video
management file.
• Appears when you attempt recording when the write/erase
37
protection tab on the SO card is set to the "LOCK" position.
• Perform clean up to restore the capacity of the recording media.
71
• Turn off the camera. Remove the card and insert it again.
19
Turn on the camera after inserting the SO card. If the error
message appears again, replace the card with one that is
certified to operate correctly.
• Appears for 5 seconds after power is turned on in recording
mode if the lens cover is closed or when it is dark.
• Appears when the date/time is not set.
17
• The built-in clock's rechargeable lithium battery is
16
discharged, so the previously set date/time is erased.
Connect the camera to an AC outlet using the AC adapter
for over 24 hours to charge the clock's lithium battery. Then
set the date/time.
• As the battery power comes close to nil, the battery
indicator blinks. When the battery power is exhausted,
power turns off automatically.
• Displays the remaining battery power.
[--I
~[-I
~ ~
High
77
Advertisement
Table of Contents
