1. Manuals
  2. Brands
  3. Toro Manuals
  4. Lawn and Garden Equipment
  5. 22368
  6. Installation instructions manual

Toro 22368 Installation Instructions Manual

Ce kit for stx-26 stump grinder
Hide thumbs
1
2
3
4
5
6
7
8
Table of Contents

Advertisement

Quick Links

Download this manual
CE Kit
STX-26 Stump Grinder
Model No. 22368
Safety
Safety and Instructional
Decals
Safety decals and instructions are
easily visible to the operator and are
located near any area of potential
danger. Replace any decal that is
damaged or missing.
107-8495
1. Parking brake
© 2021—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
decal107-8495
Register at www.Toro.com.
Form No. 3446-983 Rev A
Installation Instructions
*3446-983*
Original Instructions (EN)
Printed in the USA.
All Rights Reserved

Advertisement

Table of Contents
loading

Related Manuals for Toro 22368

Summary of Contents for Toro 22368

  • Page 1 Form No. 3446-983 Rev A CE Kit STX-26 Stump Grinder Model No. 22368 Installation Instructions Safety Safety and Instructional Decals Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or missing.

  • Page 2: Installation

    Installation Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description Qty. – No parts required Prepare the machine. Brake bar Locknut Mounting link Flange-head shoulder bolt Idler spring Flange-head nut (8 mm) Flange-head nut (9.5 mm) Long bolt Shoulder bolt Install the parking brake.

  • Page 3: Installing The Parking Brake

    Loosen the clamp bolts (Figure Push the front road wheel rearward as far as possible (Figure Installing the Parking Brake Parts needed for this procedure: Brake bar Locknut Mounting link Flange-head shoulder bolt Idler spring Flange-head nut (8 mm) Flange-head nut (9.5 mm) g007835 Figure 2 Long bolt...
  • Page 4 Connect the brake plate to the brake yoke using 3 hex nuts and the threaded rod (Figure g018756 Figure 4 g019229 1. Long bolt 8. Hex nut Figure 5 2. Flange-head shoulder bolt 9. Brake plate 1. Shoulder bolt 4. Brake handle 3.

  • Page 5: Adjusting The Parking Brake

    Ensure that the track deflects less than 0.6 to 1 Tighten the jam nut under the brake plate to cm (1/4 to 3/8 inch) when 20.6 kg (45 lb) of force secure the setting (Figure is applied to the track span. Adjust the torque on Lift the brake handle to the engaged position to the tensioning bolt as needed.

  • Page 6: Applying The Decals

    Installing the Hydraulic Applying the Decals Motor Cover Parts needed for this procedure: Parking brake decal Parts needed for this procedure: CE decal Hydraulic motor cover Bolt Procedure Procedure Clean the area where the decals will be placed and ensure that it is free of dirt, grease, or other Place the hydraulic motor cover over the motor and foreign material.

  • Page 7: Operation

    Operation Operating the Parking-Brake Lever To engage the parking brake, lift the lever upward. To disengage the parking brake, push the lever downward. g355524 Figure 10 1. Parking-brake lever...

Table of Contents