1
Adjusting the Tire Pressure
No Parts Required
Procedure
For the rake to work properly, it is important
for the machine to have the correct tire pressure.
Ensure that the tire pressure is 48 kPa (7 psi)
(Figure 3).
To get the most accurate reading, check the tire pressure
when the tires are cold.
Pressure: 48 kPa (7 psi)
2
Removing the Shipping Board
No Parts Required
Procedure
Before you can install the rake on a new machine, you must
remove the shipping board from the machine.
1. Remove the nuts, bolts, and washers securing the
shipping board to the rear of the machine.
Figure 3
2. Discard the fasteners and the shipping board.
3
Connecting the Center
Assembly and the Side
Assemblies
Parts needed for this procedure:
1
Center assembly
1
Right-side assembly
1
Left-side assembly
2
Bolt (3/4 x 3-1/2 inches)
2
Locknut (3/4 inch)
2
Long spacer
2
Cable guard
Procedure
1. Position the assemblies so that the top plate of the
center assembly faces forward and the top plate of each
side assembly faces backward (Figure 5).
4
Figure 4
G023667