Use - Washing And Drying - AEG LAVAMAT 14840 User Manual

18

Use - Washing and Drying

You can set the duration of the drying cycle according to the type of fabric. Press
the button 4 button again and again until the time you want appears on the dis-
play.
For Cottons you can select a drying time from 10 minutes to 250 minutes (hours
4.10). For Synthetic you can select a drying time from 10 minutes to 130 minutes
(hours 2.10).
Every time you press this button the drying time increases by 5 minutes.
The programme time will automatically increase by a few minutes.
Press button 8 to start the programme.
5.
After the programme has started, the time remaining is updated every minute.
If you set only 10 minutes of drying phase with the timed drying button, the appliance per-
forms only a cooling phase.
6. At the end of the drying programme, some acoustic signals sound. A blinking «0» ap-
pears on the display. The pilot light B and the light of the button 8 go off.
At this point, begins an anti-crease phase, which lasts for about 10 minutes. During
this time the door is locked. The door cannot be opened.
If you need to open the door before or during the anti-crease phase or to interrupt it, press
any button or turn the programme dial to any programme position (except O).
The door can be opened after some minutes (in any case do not force it) .
Turn the selector dial to the O position to switch the machine off.
7.
8. Remove the laundry.
Note!
The different type of cottons (towelling, sheets, shirts, and so on) or any laundry items roll-
ing up during the spinning phase may result in partial dryness.
In the exceptional case that at the end of the cycle the laundry remains slightly wet, we
suggest that you unfold the rolled up items, redistribute them evenly in the drum and se-
lect an additional drying cycle of 20-30 minutes.
USE - WASHING AND DRYING
NON-STOP programme: Washing and Automatic drying
The recommended load size is 3 kg for cotton and 2 kg for synthetic.
CAUTION!
Do not use a dosing device/ball when carrying out a washing and drying programme.
1. Load the laundry.
2. Add detergent and fabric softener.
3. Switch the machine on: turn the selector dial to the required washing programme/fab-
ric. The pilot light A illuminates.
4. Press the relevant buttons to set the required options.