Using The Appliance - Washing & Drying - AEG L 75480 WD User Manual

20 www.aeg.com
The display shows a minimum time
value.
• Each time you press this button the
time value increases by 5 minutes.
• After some seconds the time value on
the display changes: the appliance cal-
culates also the duration of the anti-
crease and the cooling phases.
• Press button
gramme. The display shows the new
time value every minute.
If you set the time value of only
10 minutes, the appliance per-
forms only a cooling phase.
At the end of the programme
• The appliance stops automatically.
11. USING THE APPLIANCE - WASHING & DRYING
11.1 NON-STOP programme -
Washing & Automatic drying
CAUTION!
Do not put a plastic device/ball
for the detergent into the
drum.
• Press button
ance.
• Load the laundry.
• Measure out the detergent and fabric
conditioner.
• Turn the programme dial to the wash-
ing programme. The display shows the
wash symbols.
CAUTION!
Do not set a spin speed lower
than the automatic speed of
the set programme.
• Set the available options.
Set time value
Final time value
4 to start the pro-
The drying symbol starts
to flash.
The door locked symbol
comes on.
1 to activate the appli-
• The acoustic signals operate.
•
In the display comes on.
• The indicator of the Start/Pause but-
ton 4 goes off.
The last minutes of the drying cy-
cle the appliance performs the
anti-crease and the cooling pha-
ses.
• Press button
to deactivate the ap-
1
pliance. After some minutes from the
end of the programme, the energy
saving function automatically deacti-
vates the appliance.
•
When the door locked symbol
goes off, you can open the door.
• Remove the laundry from the appli-
ance. Make sure that the drum is emp-
ty.
• Keep the door ajar, to prevent mildew
and odours.
• Close the water tap.
• Press the button
line appears under one of the dryness
level symbol.
The iron dry level
comes on.
The cupboard dry
level comes on.
The extra dry level
comes on.
The drying symbol
comes on.
The time value on the display is the
duration of the washing + drying cy-
cles calculated on a default load size.
• Press button
4 to start the pro-
gramme.
until the black
8