Table of Contents
Advertisement
If possible, do not set a spin speed lower than that proposed by the appliance to avoid too
long a drying time therefore saving energy.
5.
Press the button 3 to set the degree of dryness.
The pilot light B illuminates. The light corresponding to the set degree illuminates. The
display shows the drying cycle duration calculated on the maximum load size.
The pilot light of button 8 starts blinking.
6.
Press the button 8 to start the programme. After the programme has started, the time
remaining is updated every minute.
At the end of the programme, both pilot lights A and B go off; follow the indications
7.
given in the previous chapter. Then, turn the selector to the O position to switch the
machine off.
8.
Remove the laundry.
NON-STOP programme: Washing and Timed drying
The recommended load size is 3 kg for cotton and 2 kg for synthetic.
It is also possible to dry up to 4 kg of cotton items (see the «Drying Programme » table).
CAUTION!
Do not use a dosing device/ball when carrying out a washing and drying programme.
1.
Load the laundry.
2.
Add detergent and fabric softener.
3.
Switch the machine on: turn the selector dial to the required washing programme/fab-
ric. The pilot light A illuminates.
4.
Press the relevant buttons to set the required options.
5.
Press button 4 to set the drying time. Press this button again and again until the time
you want appears on the display. The pilot light B illuminates.
For Cottons you can select a drying time from 10 minutes to 250 minutes (hours 4.10).
For Synthetic you can select a drying time from 10 minutes to 130 minutes (hours
2.10).
Every time you press this button the drying time increases by 5 minutes.
The DRYING TIME value appears on the display for some seconds, then the entire dura-
tion of the washing and drying cycle appears.
If you set a washing programme and only 10 minutes of drying cycle, the total duration
displayed includes also the unrolling and the cooling phase.
6.
Press the button 8 to start the programme. After the programme has started, the time
remaining is updated every minute.
At the end of the programme, both pilot lights A and B go off. Follow the indications
7.
given in the previous chapter. Then, turn the selector to the O position to switch the
machine off.
8.
Remove the laundry.
Use - Washing and Drying
19
Advertisement
Table of Contents
