Table of Contents
Advertisement
42
Installation
When discharging into a standpipe en-
sure that the top of the standpipe is no
more than 90 cm (35.4'') and no less
than 60 cm (23.6'') above floor level.
The drain hose may be extended to a
maximum of 4 metres. An additional
drain hose and joining piece is available
from your local Service Force Centre. The joining piece must have an internal diameter
of 18 mm.
If your drain hose looks like this (see be-
low) you do not require the "U" piece".
Just push the hose firmly in to the
standpipe.
Onto a sink outlet spigot.
2.
If the outlet spigot has not been used
before, remove any blanking plug that
may be in place.
Push the drain hose onto the spigot and
secure with a clip, ensure a loop is
formed in the drain hose (see diagram)
to prevent waste from the sink entering
the appliance.
If you intend to drain the hose from the ma-
chine into a sink, make sure that the sink is
empty and the plug hole is not blocked.
Use the plastic "U - Piece" supplied.
Before connecting up the machine to new
pipework or to pipework that has not been used for some time, run off a reasonable
amount of water to flush out any debris that may have collected in the pipes.
loop
Advertisement
Table of Contents
