Returning To Factory Default Setup - Intermec EasyCoder PX6i User Manual

Chapter 6 — Setting Up the Printer

Returning to Factory Default Setup

There are three ways to return to the factory default setup of the printer:
Insert a special CompactFlash memory card and restart the printer.
A
Use the Memory Reset option in the Test/Service part of the Setup
B
Mode.
Use the printer's built-in keyboard as described below:
C
Lift the printhead.
1
Switch on the power to the printer and press the <i> key and wait
2
until the printer beeps.
Swiftly press the following keys:
3
< > < /Esc>
The following message will be displayed:
4
Factory Default?
Enter=Yes ESC=No
Within 10 seconds, press <Enter> to reset the printer to factory
5
default. The parameters will be reset and the printer will continue the
normal startup.
If you press < /Esc> or wait until the 10 seconds time-out has passed,
the normal startup will continue without any reset being performed.
Note: The factory default will remove all fi les used to store
settings. It will not reset settings that already has been read
when the fi les are removed. This means that EasyLAN Wireless
settings (SSID, keys, etc.) will retain their values from the pre-
vious start. However, the next reboot will reset them to factory
default.
56
< /Esc> < >
EasyCoder PX6i User's Guide (IPL version)