Installing Control And Rf Receiver Circuit Boards Together In The Cabinet; Standard Phone Line Connections; Figure 4. Standard Telephone Line Connections - ADEMCO N7227V5 Installation Instructions Manual

the Control and RF Receiver Circuit Boards Together in the Cabinet
Installing

Standard Phone Line Connections

The wiring connections shown here are not applicable if the 4285 Phone
module is used. Refer to the 4285 Phone module section for information
regarding phone line connections, which are different than those shown here.
TERMINALS
ON CONTROL

Figure 4. Standard Telephone Line Connections

1. Hang two short (black) mounting clips (provided with receiver) on the
raised cabinet tabs, as shown in Detail B in Figure 3.
2. Insert the top of the receiver board (removed from its own case as de-
scribed in its instruc tions) into the slots at the top of the cabinet, as shown
in Detail A in Figure 3. Make sure that the board rests on the correct row of
tabs, as shown.
3. Swing the base of the board into the mounting clips and secure it to the
cabinet with the accom panying screws (see Detail B in Fig. 3).
4. Insert the top of the control's board into the slot in the clips and position
two long (red) clips at the lower edge of the board (see Detail C).
5. Swing this board into place and secure it with two additional screws.
6. Insert grounding lugs (supplied with the receiver) through the top of the
cabinet into the left-hand terminals of the antenna blocks (at the upper
edge of the receiver board) and secure them to the cabinet top with the
screws provided, as shown in Detail D.
7. Insert the receiver's antennas through the top of the cabinet, into the
blocks' right-hand terminals, and tighten the screws.
8. Setup and wiring of the receiver. is contained in the WIRELESS (RF)
ZONE EXPANSION (5700 & 5800 RF SYSTEMS) section.
Incoming phone line and handset wiring is connected to the main terminal
block (via a RJ31X jack) as indicated below and shown in Figure 4.
Term. 17: Local Handset (TIP – Brown*).
Term. 18: Local Handset (RING – Gray*).
Term. 19: Incoming Phone Line (TIP – Green*).
Term. 20: Incoming Phone Line (RING – Red*).
*
Colors of wires in Direct Connect Cord.
Incoming
Handset Telco Line
17 18 19
– 13 –
20 21
EARTH GROUND
INCOMING TELCO LINE
DIRECT
CONNECT
TIP
CORD
RJ31X
RING
JACK
PLUG
PREMISES
PHONES