Maytag Gemini Installation Manual page 5

Locating The Anti-Tip Bracket (See Figure 4)
Installations With Alternate Outlet Receptacle (Non-Flush Mount)
If the outlet receptacle must be mounted as shown in figure
4, the range will not push back against the wall.
Therefore, the long leg of anti-tip bracket will have to be on
the floor to properly engage the leveling foot.
A. Determine where either the right or left "EDGE" of the
range will be located and mark the floor or wall.
STEP 2 - Anti-Tip Bracket Installation Options
A. Wood Construction:
1. Floor: Locate the center of the two holes identified in
figures 3 and 4 as applicable, as "HOLES FOR
FLOOR." Drill a 1/8² (3 mm) pilot hole in the center
of each hole (a nail or awl may be used if a drill is not
available). Secure the ANTI-TIP bracket to the floor
with the two screws provided. Proceed to STEP 3.
2. Wall: Locate the center of the two holes identified in
figures 3 and 4 as applicable, as "HOLES FOR
WALL." Drill an angled 1/8² (3 mm) pilot hole in the
center of each hole as shown in figure 5. (A nail or
awl may be used if a drill is not available). Secure the
ANTI-TIP bracket to the wall with the two screws
provided as shown in figure 5. Proceed to STEP 3.
B. Cement or Concrete Construction:
1. Suitable screws for concrete construction can be
obtained at the hardware store. Drill the required
size hole for the hardware obtained into the
concrete at the center of the holes identified in
NON-FLUSH MOUNT
OUTLET RECEPTACLE
(SEE FIGURE 2 FOR LOCATION
SEE FIGURES 7 & 8 FOR
ROTATION OF OUTLET
RECEPTACLE)
B. Place the bracket 15/16² (24 mm) from the marked
"EDGE" toward the center of opening and against the
back wall as shown in figure 4, with orientation hole
against floor.
C. Use the bracket as a template and mark the required
holes as shown in figure 4 for the type of construction
you will be using.
FIGURE 4
figures 3 and 4 as applicable, as "HOLES FOR
FLOOR". Secure the ANTI-TIP bracket to the floor.
Proceed to STEP 3.
-5-
FIGURE 5