Power Up And Test; Switch On; Commissioning - BT Inspiration Installation & Maintenance Manual

Power up and test

• Ensure the mains plug is fitted with a 3A cartridge fuse
• Ensure there is a reliable mains earth in the supply socket outlet. This can be done using a 13A socket
earth loop impedance tester

Switch on

• Power up the system by inserting the mains plug
• Wait 8-10 seconds for the system power up routine to be complete. During this period you will hear
several clicks from the working system as relays are energized
• Check that the vital activity LED on the Base Motherboard is flashing
• The Featurephones display the product name and software revision for about 1.5 seconds

Commissioning

1. Remove any anti-scratch protective film from Featurephone LCDs
2. Label up all Featurephones and other telephones.
3. Ensure that all Featurephones provide dialling tone, ringing and Handsfree (loud speaking) facilities.
Check that the display is not showing corrupt information.
4. Reset the system to default
5. Check that all other telephones are connected for dialling and ringing.
6. Make essential changes from the default, for example:
PSTN System
Equipped Exchange lines
Disconnect unused extensions
Enable features on the system for specific configurations
PSTN System
Enable DISA
Fax Detect
VoiceMail (Answer machine on I/C lines)
Program Door Intercom
Program PA position
Forward Recall - If system is piggy-backed
MF/LD signalling
Note
As the BT Inspiration can support both ISDN and PSTN , it may be necessary to enable features for
ISDN and PSTN options on the same system.
ISDN System
Equipped Exchange lines
Disconnect unused extensions
ISDN System
P to P or P to MP
Set BASE MSN & DDI index numbers
CLI Routing
VoiceMail (Answer machine on ISDN lines)
Program Door Intercom
Program PA position
PBX access - If system is piggy-backed
Page 54