Table Of Zones; Interpreting Zone Diagnostics - Viper 671XV Owner's Manual

table of zones

The zone number is the number of in-vehicle LED flashes used
by the system to identify that input. The standard input assign-
ments are listed below, along with spaces to write in any optional
sensors or switches you have had installed.
Zone - Number
of LED Flashes
1
2
3
4
5

interpreting zone diagnostics

Warn Away responses are not reported by arming or disarming
diagnostics. If you receive a Bypass notification when arming or
a Tamper Alert notification when disarming, look at the in-
vehicle status LED. Active or triggered zones will be indicated by
a pattern of blinks by this LED.
Example
If Zone 3 was active or triggered, the in-vehicle LED will blink
three times with a two-second pause. Then it will blink three
times again, and repeat until the ignition is turned on.
note: Your system stores the last two triggered zones in
memory. If your system has been triggered but the LED
has been reset by turning on the ignition, your dealer can
still recall the last two zones that were triggered. Contact
your dealer for details.
© 2004 directed electronics, inc.
Description
Instant trigger - often used
for hood/trunk pinswitches
A heavier impact
detected by the shock sensor
Door switch trigger
For optional sensors
Ignition trigger
Dealer-Installed
Options
23